A: Arm the alarm and wait for about 30 seconds to a minute. Jack up the car (tilt sensor) or sit in the car with the doors locked and move around (interior motion sensor). Q: Anything I should be aware of when I bring my car in to get the alarm activated?
0:000:57How To Turn On-Off Your BMW Panic Alarm - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the only thing you need to do is press. And hold this unlock the trunk you just press it and holdMoreSo the only thing you need to do is press. And hold this unlock the trunk you just press it and hold it in for about three four seconds. You notice that the panic goes on and to stop.
RegisteredTurn the car to position 2 (middle) and turn it back to OFF. Do this 5 times without any time gap. ... Remove the key and do the following immediately within 30 seconds.Press and hold UNLOCK and tap the center BMW button 3 times. ... Immediately within afterwards, repeat step 3 for your second or third key.Jun 5, 2011
The anti-theft alarm system protects the vehicle against unauthorised access by activating the hazard lights and setting off an acoustic alarm.
There are two main events that will trigger the alarm -- one happens if the doors are opened, the other happens if motion is detected inside the car. In BMW's in general, there have been issues with the interior motion sensor giving false alarms.Oct 1, 2014
The alarm gets triggered when the car is parked; there is no one near the car. ... If your BMW alarm keeps going off, the problem is often caused by a stuck or defective BMW hood switch. The most common solution that will fix this problem is to replace the BMW hood switch.
Locate the fuse box containing the alarm fuse. It is usually located on the dashboard by the driver's door, in front of your left knee. You may find the alarm fuse in this fuse box. If you do not find an alarm fuse inside of the car, look in the fuse box under the hood on the driver's side.
If it beeps, it means it has the alarm siren, thus the alarm. Just roll down the window, lock the car, then stick your hand in the window. If you have the alarm it will sound off then.Dec 26, 2010
1:097:47How to Tell if you have a Factory Alarm / Security SystemYouTubeStart of suggested clipEnd of suggested clipSo the first thing you're going to do is you're going to turn on the ignition. Don't run the motorMoreSo the first thing you're going to do is you're going to turn on the ignition. Don't run the motor and roll the windows. Down.
If the vehicle has been damaged during an attempt to break in or steal it, then the anti-theft system might have been engaged. Check to see if the lock cylinder is damaged and also underneath the door handle where a screwdriver might have been used by a would-be thief.
To reset a factory car alarm, first try pressing the “panic” button on your remote if you have one. If that doesn't do it, put your key in the driver's door in the unlock position, hold it for 2 seconds, then open the door.
until the engine is started, but no longer than approx. 5 minutes: An alarm has been triggered. The indicator lamp flashes normally before unlocking even when the alarm has been triggered.Feb 5, 2016
To switch off the alarm: press any button. > Unlock the car with the remote control, , or insert the remote control all the way into the ignition lock. > The indicator lamp under the inside rearview mirror flashes continuously: the system is armed.